Bowl slides
Single, honeycomb and built-in-screen bowls.
Dept / Glass parts
Bowls, Stems & Parts
Replacement bowls, downstems, ash catchers, adapters and screens. Bring your piece in and we’ll match the joint.
What we carry
Keep your piece running
Every part that breaks, clogs or gets lost.
Downstems
Diffused and open-ended stems from 2 to 6 inches.
Ash catchers
Keep your main piece cleaner, longer.
Adapters & drop-downs
Convert sizes, change gender or lower the angle.
Screens
Brass, stainless and glass daisy screens.
Silicone caps & plugs
Keep water in and smell out between sessions.
Percolator add-ons
Inline and tree percs that slot into your setup.
Keck clips
Plastic clips that lock joints together.
Brands shown are examples. Stock changes, so call ahead for a specific item.
How-to
Measure your downstem
Downstems are sold by length. Measure once and you’ll never buy the wrong one.
Step 01
Pull it out
Remove the old downstem, or look at where it would sit.
Step 02
Measure
Measure from the bottom of the joint ring to the tip of the stem, in inches.
Step 03
Check the joint
Note the joint size (10, 14 or 18 mm) at the top of the stem and at the bowl.
Step 04
Match the water
Pick a length that sits about an inch under the water line.
| Joint | Outer diameter | Typical use |
|---|---|---|
| 10 mm | ~10 mm | Mini rigs and small bubblers |
| 14 mm | ~14.5 mm | Most bongs and rigs |
| 18 mm | ~18.8 mm | Large water pipes |
All glass is sold for tobacco use only.
Not sure what to pick? Take the four-question Smoke Sommelier quiz and get a pairing from the crew. Start the quiz →
From the blog
Guides for this department
Short reads from the crew before you buy.
Glass & Dab · 3 min read
How to Clean a Bong: The 10-Minute Method That Actually Works
The salt-and-isopropyl shake, what to use on every material, and a weekly routine that keeps glass crystal clear.
Read the guideGlass & Dab · 3 min readPercolators Explained: Tree, Showerhead, Honeycomb and More
What a perc does, how the common types compare, and whether you need one for your first water piece.
Read the guideGlass & Dab · 3 min readHow to Choose Your First Glass Piece
Beakers vs. straight tubes, wall thickness, percolators and joint sizes without the jargon.
Read the guideFAQ
Questions, answered
How do I know my joint size?
Measure the outer diameter of the male joint: about 10, 14.5 or 18.8 mm. Or bring the piece in and we’ll check it.
What does male and female mean?
Male joints fit inside. Female joints are the opening. A male bowl fits a female downstem.
Do I need an ash catcher?
Not required, but it keeps your main piece cleaner and adds a little filtration.
What length downstem do I need?
Measure from the joint ring to the tip. The tip should sit about an inch below the water line.
Do you have replacement parts for my brand?
We carry parts for the most common setups. Bring the piece for the best match.
Near you
Bong parts near you in Santa Ana
Need a new bowl or downstem in Santa Ana? X Rated stocks replacement glass parts in every common joint size. Bring your piece and we’ll match it.
- Santa Ana
- Tustin
- Orange
- Garden Grove
- Costa Mesa
- Fountain Valley
- Irvine
- Westminster
- Anaheim
- Downtown Santa Ana
- South Coast Metro